AWAZEL Maxplug 5 kg per Can

78.00 د.إ 78.0 AED

78.00 د.إ

Add to Cart

MAXPLUG® is a quick-setting cement-based
mortar that instantly stops running water from
cracks, fissures, holes or other openings in
concrete and masonry. It is non-shrink and
sets within three to five minutes depending on
the temperature. Once MAXPLUG® sets, it
adheres perfectly to the substrate. It only
requires water for mixing.

APPLICATION FIELDS
· Sealing of leaks in concrete surfaces, solid
masonry and other sound substrates
wherein water flows through cracks and
holes.
· Emergency repairs on concrete water
pipes. For broken concrete pipes,
MAXPLUG® will even work when the
concrete pipes are under hydrostatic
pressure.
· Emergency plugging of gas leaks.
· Sealing of concave corners and working
joints, filling the grooves with MAXPLUG®
in the shape of a cove.
· Anchoring of bolts and other accessories
that require immediate use.
· Stopping running water in basements,
tunnels, foundations and sewers under
hydrostatic pressure.
· It is a suitable maintenance material for
homes and industry.

ADVANTAGES
· Does not shrink or become weak due
to its exothermic reaction.
· MAXPLUG® increases in volume,
giving a permanent seal in areas
where there is flowing water.
· Its quick setting-time from 3 to 5
minutes can be controlled, either sped
up or slowed down, by adding warm or
cold water. Setting may even be
instantaneous by adding hot water
during warm weather.
· Its mechanical properties are similar or
higher than concrete.
· Non-toxic. It can be used in contact
with drinking water.
· It sets even underwater.
· Does not contain chlorides or other
corrosive compounds.
· Easy to use.

APPLICATION INSTRUCTIONS
Surface Preparation
Cracks or fissures must be opened to a
minimum depth of 4 cm and a width from 3
to 4 cm. In order to provide a good
mechanical key, make a square-shaped
groove; preferably dovetail to the surface to
which the material is applied. Avoid a "V"
shape, as shown in drawings.

Clean the surface until it is free of any loose or
unsound materials or surface contaminants. If
there is no water present at the time of
application, dampen the surface before
applying MAXPLUG® .
Mixing
Mix only the amounts of MAXPLUG® that
it can be applied within 3 minutes under
normal conditions. If flowing water is present,
only the amount of material that can be applied
by hand should be mixed.

CONSUMPTION
One kg of MAXPLUG® fills about 0,615-
0,620 l, depending on the amount of
mixing water (approximately 1,62 kg/ l ).

PACKAGING
MAXPLUG® is supplied in 25 kg drums
and 5 kg cans.

STORAGE
Twelve months in its original unopened
packaging. It should be stored in a dry,
fresh and covered place protected from
humidity, sunlight and frost, at
temperatures above 5 ºC.




Website Visitors - 37958